Difference between revisions of "Ryde GPIO breakout"
Jump to navigation
Jump to search
| Line 5: | Line 5: | ||
===Construction notes=== | ===Construction notes=== | ||
| − | Note the GPIO board requires 5v NOT 12v! | + | * Note the GPIO board requires 5v NOT 12v! |
| + | |||
| + | * The GPIO header is placed on the opposite side of the PCB to the rest of the components. | ||
===Bill of materials=== | ===Bill of materials=== | ||
Revision as of 09:56, 31 July 2020
To help constructors connect easily to the Ryde RPIO, BATC has produced a small daughter board - PCBs will be availble in the BATC shop.
Construction notes
- Note the GPIO board requires 5v NOT 12v!
- The GPIO header is placed on the opposite side of the PCB to the rest of the components.
Bill of materials
A full bill of materials will follow but the schematic is shown below.
