Difference between revisions of "Ryde Hardware"

From BATC Wiki
Jump to: navigation, search
Line 12: Line 12:
 
===Video and Audio Output===
 
===Video and Audio Output===
  
The HDMI display should be connected to the primary HDMI output - that's the one .... Audio will then be sent to the HDMI device.  In this case there is no audio or video from the RPi 3.5 mm jack.
+
The HDMI display should be connected to the primary HDMI output - that's the one nearest the USB-C port and SD Card. Audio will then be sent to the HDMI device.  In this case there is no audio or video from the RPi 3.5 mm jack.
  
 
If composite video output is selected from the ssh console menu, then video (selectable PAL or NTSC) and audio is available on the RPi 3.5 mm jack and the HDMI outputs will be inactive.
 
If composite video output is selected from the ssh console menu, then video (selectable PAL or NTSC) and audio is available on the RPi 3.5 mm jack and the HDMI outputs will be inactive.
  
There is no current configuration which will output audio on the RPi Jack whilst the HDMI monitor is in use, or will send output to both the HDMI and RPi 3.5 mm jacks simultaneously.
+
There is no current configuration which will output audio on the RPi Jack whilst the HDMI monitor is in use, or that will send output to both the HDMI and RPi 3.5 mm jacks simultaneously.
  
 
====Project cases====
 
====Project cases====

Revision as of 08:56, 16 July 2020

The Ryde Receiver is based around a Raspberry Pi 4 (exact model to be decided).

The hardware currently required is as follows - note this may change and you buy at your on risk!

  • Raspberry Pi 4 and heatsink / fan
  • 5 volt 3amp PSU - this may be connected directly to the RPi GPIO pins, see Ryde GPIO Connections
  • Sandisk Ultra 8GB+ SD card - Pre-programmed cards may be available from the BATC shop once the project is on general release
  • Micro to standard HDMI converter - needed to connect the RPi HDMI output to a standard monitor
  • IR receiver and remote control - see this wiki page for more details:Ryde remote controls
  • MiniTiouner V2 hardware - the Ryde phase 1 hardware connects to the standard hardware using USB

Video and Audio Output

The HDMI display should be connected to the primary HDMI output - that's the one nearest the USB-C port and SD Card. Audio will then be sent to the HDMI device. In this case there is no audio or video from the RPi 3.5 mm jack.

If composite video output is selected from the ssh console menu, then video (selectable PAL or NTSC) and audio is available on the RPi 3.5 mm jack and the HDMI outputs will be inactive.

There is no current configuration which will output audio on the RPi Jack whilst the HDMI monitor is in use, or that will send output to both the HDMI and RPi 3.5 mm jacks simultaneously.

Project cases

Most of the early development protypes are being hosted on old STB cases - these provide a case, possibly a PSU and IR detector diode and front panel switches.

An example prototype hardware is shown here:

Inside Case Small.jpg