Ryde Hardware

The Ryde Receiver is based around a Raspberry Pi 4 (exact model to be decided).

The hardware currently required is as follows - note this may change and you buy at your on risk!

• Rapberry Pi4 and heatsink / fan
• Sandisk Ultra 8GB+ SD card - Pre-programmed cards will be available from the BATC shop once the project is on general release
• Micro to standard HDMI converter - needed to connect the RPi HDMI output to a standard monitor
• IR receiver and remote control - see below
• MiniTiouner V2 hardware - the Ryde phase 1 hardware connects to the standard hardware using USB

Project cases

Most of the early development protypes are being hosted on old STB cases - these provide a case, possibly a PSU and IR detector diode and front panel switches.

An example prototype hardware is shown here:

IR remote controls

see this wiki page for more details:Ryde remote controls