View source for Serit tuner

As of February 2017 the Sharp and Samsung NIMs are no longer available and the MiniTiouner project will use a NIM from Serit (FTS-4335) which covers from 143.75MHz right through to 2450 MHz without the need for any upconverters.


The first prototype was shown at CAT16 by Jean-Pierre F6DZP - you can watch a video of his presentation on the [https://www.youtube.com/watch?v=qMSwRDpAsc0&index=5&list=PLhLAVxsCvzNCug95lETI5ZcwtK1AkWvi8 BATC Youtube channel].


[[File:Serit.JPG|400px]]

===Feedback===

Please use the BATC forum for any feedback on this project http://www.batc.org.uk/forum/viewtopic.php?f=15&t=4853

===Dual receiver===

The Serit FTS4335 NIM is capable of receiving more than one signal simultaneously; however the BATC hardware and software can only receive one signal at a time.   There is provision for a socket on the converter PCB to connect to the second receive output of the FTS4335V for experimentation. F6DZP's dual receive software is still under development and may be available for testing. See his web site at:  http://www.vivadatv.org

Even though only one transmission can be received at any time with this converter PCB, it is possible to select which of the two antenna sockets is used, allowing one of two antennas / converters to be connected.

===Filters and pre-amps===

The wide band coverage makes building a receiver for 146 or 437 much easier, although you will need a pre-amp followed by lots of filtering for each band, just like the Sharp did, and probably followed by a Satellite line amp from ebay as the Serit FTS-4335 has less gain than the Sharp.

[[Filters|Filter designs are available here]]

===Software===
To use the FTS4335 NIM with the MiniTiouner, you will need to run Ver 0.6d or later versions of the excellent MiniTioune software.  This is available for [http://www.vivadatv.org/viewtopic.php?f=60&t=416 download from the Viva DATV forum here] and will work with Sharp, Eardatek or Serit NIMs. You need to register on the Viva DATV forum before being able to download.

===Adapter card===

Also, due to a different pinouts from the Sharp NIM, the Serit FTS4335 NIM will also need a simple adapter board to enable it to be plugged in to the MiniTiouner.

Brian G4EWJ has designed a PCB and the blank board plus a full set of (leaded) components and the Serit FTS-4335V NIM is available [https://batc.org.uk/shop/minituner in the BATC shop].


[[File:serit kit2.JPG|400px]]      [[File:serit kit1.JPG|400px]] 

==Adapter Instructions, Parts List, Schematic, Silkscreen==

[[media:Serit_FTS4335V_Converter_Kit_MTK2_Instructions_v1-07_Parts_Build_A1_v1_Schematic_A1_v2_Silkscreen.zip]]