Difference between revisions of "PicoTuner Ethernet Interface"
| Line 1: | Line 1: | ||
In progress . . . | In progress . . . | ||
| − | =PicoTunerWH (PicoTuner | + | =PicoTunerWH (PicoTuner in WinterHill mode)= |
The basic Pico module on the standard USB connected PicoTuner can be replaced by a WIZnet W5100S-EVB-Pico or W5500-EVB-Pico module. | The basic Pico module on the standard USB connected PicoTuner can be replaced by a WIZnet W5100S-EVB-Pico or W5500-EVB-Pico module. | ||
| Line 8: | Line 8: | ||
[[File:W5100s-evb-pico-2.png|400px]] | [[File:W5100s-evb-pico-2.png|400px]] | ||
| + | |||
| + | =Overview= | ||
| + | |||
| + | PicoTuneWH is software for the BATC PicoTuner board that emulates a single NIM WinterHill | ||
| + | and receives two signals at the same time, with commands and received data being sent over Ethernet. | ||
| + | |||
| + | There is no transport sream transfer by USB. A USB connection is not required. | ||
| + | |||
| + | There are different .uf2 files for W5100S-EVB-Pico and W5500-EVB-Pico modules. | ||
| + | |||
| + | There is a debug facility over the USB serial port. | ||
| + | |||
| + | It may be possible to use this software with OpenTuner (0.B). | ||
| + | |||
| + | Network multicast is not supported. | ||
| + | |||
| + | A broadcast packet with device and receive info is transmitted every second on port 9997, even if DHCP is unsuccessful. | ||
| + | |||
| + | If you do not have a WinterHill, see the BATC Wiki, particularly the Documentation and PC Software sections. | ||
Revision as of 08:44, 23 July 2024
In progress . . .
PicoTunerWH (PicoTuner in WinterHill mode)
The basic Pico module on the standard USB connected PicoTuner can be replaced by a WIZnet W5100S-EVB-Pico or W5500-EVB-Pico module.
The provides two receivers which can be controlled over the Ethernet connection and can send the received transport streams via the Ethernet connection, similar to a WinterHill.
Overview
PicoTuneWH is software for the BATC PicoTuner board that emulates a single NIM WinterHill and receives two signals at the same time, with commands and received data being sent over Ethernet.
There is no transport sream transfer by USB. A USB connection is not required.
There are different .uf2 files for W5100S-EVB-Pico and W5500-EVB-Pico modules.
There is a debug facility over the USB serial port.
It may be possible to use this software with OpenTuner (0.B).
Network multicast is not supported.
A broadcast packet with device and receive info is transmitted every second on port 9997, even if DHCP is unsuccessful.
If you do not have a WinterHill, see the BATC Wiki, particularly the Documentation and PC Software sections.