Repeater system basic IR configuration

The section of the config file for basic IR configuration is shown here for an HDMI switch with the following control codes:

Function	IR Code
Input 1	0x17
Input 2	0x12
Input3	0x59
Input 4	0x08
Quad	0x18

# Input config
# Recommended gpio pins for "input active" are 32, 35, 18, 22, 16, 19 and 21

# announcemediatype determines the player used

# Switcher can use "ir" or "gpio" or "i2c"
# IR uses a TX on GPIO pin 12
# GPIO uses pins 36, 37, 38, 33, 31, 29, 23, 24.  Can be enabled with ir or i2c
# i2c uses FMS6501A on Output channel 1
# activeinputhold (yes/no) means that lower priority inputs do not get replaced by higher priority (except pri 1)
# Show Quad is yes/no and overides activeinputhold

# Number of available inputs does not include the controller, so is max 3 for a 4-input switch
availableinputs=3
activeinputhold=no
# Set next parameter to no if you do not want (or do not have) a quad display
showquadformultipleinputs=yes
cascadedswitches=no

outputswitchcontrol=ir
showoutputongpio=yes
outputhdmiresetcode=nec:0x17
outputhdmiquadcode=nec:0x18
outputi2caddress=3
outputi2cquadchannel=9

input0name=Controller
output0code=nec:0x17
output0hdmiswitchpin=36
output0i2cchannel=1
output0audioi2cbit=0

input1name=70cms Ryde
input1prioritylevel=1
input1activegpiopin=32
output1code=nec:0x12
output1hdmiswitchpin=37
output1i2cchannel=2
output1audioi2cbit=1
input1announcemediatype=jpg
input1announcemediafile=/home/pi/tmp/input1.jpg
input1announcemediaduration=3

input2name=23cms Ryde
input2prioritylevel=2
input2activegpiopin=35
output2code=nec:0x59
output2hdmiswitchpin=38
output2i2cchannel=3
output2audioi2cbit=2
input2announcemediatype=jpg
input2announcemediafile=/home/pi/tmp/input2.jpg
input2announcemediaduration=3

input3name=Stream rxr
input3prioritylevel=3
input3activegpiopin=18
output3code=nec:0x08
output3hdmiswitchpin=33
output3i2cchannel=4
output3audioi2cbit=3
input3announcemediatype=jpg
input3announcemediafile=/home/pi/tmp/input3.jpg
input3announcemediaduration=3