Ryde GPIO breakout

From BATC Wiki
Jump to navigation Jump to search

To help constructors connect easily to the Ryde RPIO, BATC has produced a small daughter board - PCBs will be available in the BATC shop.

Ryde1.png

Construction notes

  • Note the GPIO board requires 5v NOT 12v!
  • The GPIO header is placed on the opposite side of the PCB to the rest of the components.
  • Pay attention to the orientation of the resistor arrays - they are not the same.
  • Build the top side first, start with the resistors, then the resistor arrays, then the 16 way, then the headers, finally fit the 40 way on the other side of the PCB.

Bill of materials

A full bill of materials will follow but the schematic is shown below.

Ryde GPIO6.png

Ryde GPIO 1.jpg

Retrieved from ‘https://wiki.batc.org.uk/index.php?title=Ryde_GPIO_breakout&oldid=7361’