View source for DATV repeater DTMF commands

 Back to [[Repeater Controller|repeater controller]] main page

The BATC repeater controller uses an onboard DTMF detector which detects DTMF from the mic input on a USB audio dongle (using a standard Portsdown white USB dongle).  This can be fed from the main input audion, 144.750 rxr or a separate control rxr.

The DTMF decoder enables off-air control of some repeater functions.  

===DTMF commands===

The command sequence is in the format *xx# but the length of the sequence is variable so a command could be *123456# if required.

===Configuration file===
The actual DTMF command for each function is entirely flexible and is set in the config file.  

It is recommended that some command sequences such as shut down are not publicly available.  

See this page for a typical config file listing where the DTMF commands have been grouped as keeper commands - [[Repeater Controller configuration]].

==Functions controlled by DTMF==
The repeater functions which can be commanded by DTMF are set in the controller software and listed below - these cannot be changed.

====Suggested keeper functions====
dtmfkeepertxoff

dtmfkeepertxon

dtmfkeeperreboot

dtmftalkbackaudioenable

dtmftalkbackaudiodisable

====User codes for direct input select (use dtmfreset to deselect)====
dtmfreset

dtmfstatusview

dtmfquadview

dtmfselectinput0

dtmfselectinput1

dtmfselectinput2

dtmfselectinput3

dtmfselectinput4

dtmfselectinput5

dtmfselectinput6

dtmfselectinput7

===RPi GPIO Accessory DTMF Control examples===
dtmfoutputs=1

dtmfgpioout1pin=15

dtmfgpioout1label=shack_light

dtmfgpioout1on=31

dtmfgpioout1off=41

dtmfinputs=1

dtmfgpioin1pin=8

dtmfgpioin1label=cabinet_door

===i2c Accessory DTMF Control examples===

MCP23017. Max 16 lines either in or out

i2cioaddress=0

i2cdtmfoutputs=1

i2cdtmfgpioout1pin=a0

i2cdtmfgpioout1label=shack_heater

i2cdtmfgpioout1on=51

i2cdtmfgpioout1off=61

i2cdtmfinputs=1

i2cdtmfgpioin1pin=b0

i2cdtmfgpioin1label=cabinet_lid