Difference between revisions of "Portsdown DMM Display and Logger"

From BATC Wiki
Jump to navigation Jump to search
Line 13: Line 13:
 
It is recommended that the opto-isolator is fitted between the test point and Vdd with a 1K5 resistor in series.  This means that there is only a marginal increase in supply current.  I connected the output of the opto-isolator to a 3.5mm jack socket mounted on the front of the meter.
 
It is recommended that the opto-isolator is fitted between the test point and Vdd with a 1K5 resistor in series.  This means that there is only a marginal increase in supply current.  I connected the output of the opto-isolator to a 3.5mm jack socket mounted on the front of the meter.
 
[[File:Internal Mod.jpg|200px]]
 
[[File:Internal Mod.jpg|200px]]
[[:File:Opto socket.jpg|200px]]
+
[[File:Opto socket.jpg|200px]]

Revision as of 16:12, 23 October 2022

The Portsdown Digital Multimeter display and logger works with a modified Parkside PDM300 C3 multimeter (seasonally available for £11.99 from Lidl) to display and log the meter readings.

PDM 300 C3.jpg

Initial proof-of-concept functionality is limited to a large display of the voltage reading. Based on user feedback, further features will be added.

Modification of the DMM

Warning - this modification relies on careful construction and an opto-isolator to keep up to 300V AC away from yourself and your Portsdown Raspberry Pi. DO NOT attempt this modification if you are not confident in your construction abilities.

The DMM has an internal (live at the measurement voltage) test point where an opto-isolator can be connected to pick up a 2400 baud serial data stream. Most published modifications (https://www.mikrocontroller.net/articles/Multimeter_PDM-300-C2_Analyse#Testpunkte and https://github.com/benedikts-workshop/ParksideView) recommend fitting the opto-isolator between the test point and ground. However, this draws current for 90% of the time and significantly reduces the internal 9v battery life.

It is recommended that the opto-isolator is fitted between the test point and Vdd with a 1K5 resistor in series. This means that there is only a marginal increase in supply current. I connected the output of the opto-isolator to a 3.5mm jack socket mounted on the front of the meter. Internal Mod.jpg Opto socket.jpg