Difference between revisions of "Serit LNB DC supply"

From BATC Wiki
Jump to navigation Jump to search
Line 12: Line 12:
 
[[File:serit rfc.JPG|400px]]
 
[[File:serit rfc.JPG|400px]]
  
 +
Dave M5TXJ posted [https://forum.batc.org.uk/viewtopic.php?f=105&t=6158#p20033 this modification on the BATC forum] using a 10uh wire ended inductor.
 +
 +
[[File:5222019161032.jpg|400px]]
  
 
===LNB power supply with current limit for MiniTiouner===
 
===LNB power supply with current limit for MiniTiouner===

Revision as of 12:54, 9 September 2019

A number of people on the BATC forum have reported their Serit tuners are no longer outputting the LNB voltage from one of the F sockets. The cause is inevitably an open circuit inductor (L101 or L102) after the output has been accidently short circuited.

This page describes how to repait the tuner and also a new PCB with DC current limiting available from the BATC shop.

Repairing the Serit DC output

It is very easy to blow up the RF choke feeding DC to the F type inputs before connecting to a dummy load or short circuit antenna - or by just shorting the centre pin to ground. The result is DC on the connector on the main board but no DC on the F type center.

Each F type is fed by a seperate RFC which looks like a ceramic capacitor and is shown in the picture below. These can be replaced with care with a normal leaded RFC or SMD RFC.

Serit rfc.JPG

Dave M5TXJ posted this modification on the BATC forum using a 10uh wire ended inductor.

5222019161032.jpg

LNB power supply with current limit for MiniTiouner

In CQ-TV 265 (Sept 2019) Colin, G4KLB, describes an add on PCB to provide current limiting using the RT5047 device.

The PCB will be available form the BATC shop.

Parts list File:RT5047 LNB POWER REV 2-1 PARTS.xlsx

Schematic PDF File:RT5047 LNB Power.pdf


Schematic

RT5047 LNB POWER REV 2-1.jpg

PCB fitted to standard enclosure

IMG 9402.jpg

PCBs

IMG 9631.jpgIMG 9634.jpg

Wiring to MiniTiouner v2.0

Pin 1.jpg

Pin 2.jpg