Software Capability Matrix

From BATC Wiki
Revision as of 09:44, 8 April 2017 by G8GKQ (talk | contribs)
Jump to navigation Jump to search

There are 77 major modes that can be selected from the Portsdown Console Menu. This table is a guide to the modes that work, or are in various stages of development. An X means that the mode does not work or does not make sense. Please read with the notes below.


Output: IQ QPSKRF BATC STREAMER DIGITHIN 29 DATVEXPRESS IP
Source
CAMH264 Working 1 Working 2 Working 3 Working 4 X Working 5 ? 6
CAMMPEG-2 Working 7 Working 8 Working 3 Working 4 X Working 9 ? 6
FILETS X
PATERNAUDIO Working 10 Working 11 ? ? X Working 12 ? 6
CARRIER Working 13 ? 14 X X X Working 15 X
TESTMODE Working 16 X X X X X X
IPTSIN Working 17 ? 18 ? ? X ? X
ANALOGCAM Working 19 Working 20 X 21 X 21 X X 22 ?
VNC ? ? ? ? X ? ?
DESKTOP Working 23 Working 24 ? ? X Working 25 ? 6
CONTEST Working 26 Working 27 ? ? X Working 28 ? 6

NOTES

Please feel free to contribute your experiences to this page.

1. CAMH264 transmits an H264 704 x 576 image from the RPi Camera at SRs from 125KS up to over 4MS with the Portsdown filter-modulator board. The image is also displayed on the touchscreen if the viewfinder is not turned off. No sound is transmitted.

2. QPSKRF uses software to generate a dirty H264 QPSK DVB-S RF signal on one of the GPIO pins with harmonics at up to 437 MHz. The maximum SR available is about 400KS. No sound is transmitted.


3.

4.

5.

6.

7.

8.

9.

10.

11.

12.

13.

14.

15.

16.

17.

18.

19.

20.

21.

22. Not working yet, possibly due to an RPi USB traffic capacity issue. The Analogue input and the DATV Express output both go through the same USB controller and it is suspected that it is overloaded. It is hoped to resolve this issue in the future.

23.

24.

25.

26.

27.

28.

29. DigiThin mode has not been tested, but may well work. Please e-mail G8GKQ if you are prepared to test and use this mode - I can help!