Ryde GPIO breakout: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 8: | Line 8: | ||
* The GPIO header is placed on the opposite side of the PCB to the rest of the components. | * The GPIO header is placed on the opposite side of the PCB to the rest of the components. | ||
* Pay attention to the orientation of the resistor arrays - they are not the same. | |||
* Build the top side first, start with the resistors, then the resistor arrays, then the 16 way, then the headers, finally fit the 40 way on the other side of the PCB. | |||
===Bill of materials=== | ===Bill of materials=== | ||
Revision as of 10:11, 31 July 2020
To help constructors connect easily to the Ryde RPIO, BATC has produced a small daughter board - PCBs will be available in the BATC shop.
Construction notes
- Note the GPIO board requires 5v NOT 12v!
- The GPIO header is placed on the opposite side of the PCB to the rest of the components.
- Pay attention to the orientation of the resistor arrays - they are not the same.
- Build the top side first, start with the resistors, then the resistor arrays, then the 16 way, then the headers, finally fit the 40 way on the other side of the PCB.
Bill of materials
A full bill of materials will follow but the schematic is shown below.
