Difference between revisions of "MiniTioune software"

From BATC Wiki
Jump to navigation Jump to search
Line 12: Line 12:
  
 
* Install the D2XX drivers 2.12.24 found at http://ftdichip.com/Drivers/D2XX.htm. There's a link in the right column for a setup executable. This stage is missing from W6HHC notes.
 
* Install the D2XX drivers 2.12.24 found at http://ftdichip.com/Drivers/D2XX.htm. There's a link in the right column for a setup executable. This stage is missing from W6HHC notes.
* Install the FT2232H USB driver for the MiniTiouner board
 
* Inspect the FT2232H USB-controller module (preprogramed by BATC for NIMtuner) for correct internal memory programming
 
 
* Install LAVfilters CODECs and test the HW board and test the DirectShow filters
 
* Install LAVfilters CODECs and test the HW board and test the DirectShow filters
 
* Look in the Minitiouner folder that you've just copied to C:\ for the small program "Install_usrc_ax_winXP" and run this to install the link with the decoder.  
 
* Look in the Minitiouner folder that you've just copied to C:\ for the small program "Install_usrc_ax_winXP" and run this to install the link with the decoder.  
 
* Run the MiniTiouner_v0.6d executable & perhaps adjust the decoder filters being used.
 
* Run the MiniTiouner_v0.6d executable & perhaps adjust the decoder filters being used.

Revision as of 06:00, 12 May 2017

The MiniTiouner USB receiver uses free to download DVB-S receive and analysis software called "Minitioune" written by F6DZP. The Software is hosted on the VivaDATV forum. You need a log-in to download, but here are the links:

The latest (28 February 2017) version of MiniTioune V0.6d: Minitioune v0.6d download

Noise Power Measurement Software: ( included in the Minitioune software package)

Software Installation

 There is a "readme.pdf" in the Minitioune software package that gives the latest information and a step by step guide

For a step by step guide on how to do this, see the paper written by W6HHC - http://www.w6ze.org/DATV/InstallingMiniTiouner_onWin10.pdf

  • Install the D2XX drivers 2.12.24 found at http://ftdichip.com/Drivers/D2XX.htm. There's a link in the right column for a setup executable. This stage is missing from W6HHC notes.
  • Install LAVfilters CODECs and test the HW board and test the DirectShow filters
  • Look in the Minitiouner folder that you've just copied to C:\ for the small program "Install_usrc_ax_winXP" and run this to install the link with the decoder.
  • Run the MiniTiouner_v0.6d executable & perhaps adjust the decoder filters being used.