Difference between revisions of "Repeater Controller configuration"

From BATC Wiki
Jump to navigation Jump to search
Line 11: Line 11:
 
==1 Behaviour==
 
==1 Behaviour==
  
1 - Audio keepalive.  Some HDMI switches shut down the audio channel is no audio is present.  This option puts low-level white noise on the controller audio out to prevent this from happening.
+
1 - Audio keepalive.  Some HDMI switches permanently shut down the audio channel is no audio is present.  This option puts low-level white noise on the controller audio out to prevent this from happening.
  
 
2 - Transmit enable.  Enables transmit key line on pin xx
 
2 - Transmit enable.  Enables transmit key line on pin xx

Revision as of 18:15, 13 February 2022

This page describes the set up of the BATC repeater controller - it should only be attempted by advanced users.

Enter the repeater controller menu log in to the RPi by SSH using a program such as Putty and type menu.

Controller main.JPG

Reload

Loads the configuration changes you have made and restarts the controller

1 Behaviour

1 - Audio keepalive. Some HDMI switches permanently shut down the audio channel is no audio is present. This option puts low-level white noise on the controller audio out to prevent this from happening.

2 - Transmit enable. Enables transmit key line on pin xx

3 - Beacon mode. Enables the controller to just run in beacon mode and ignore all inputs.

4 - Power save. Enables transmit key line to be on continuously or just when the controller sees a valid input signal or when sending an ident.

5 - Operating hours. Selection of transmit key line to be active continuously or just during a timed period to save power. If timed, select the start and stop times.

6 - Quiet hours repeat. If Timed operation was selected in menu 5, you can set if the repeater should repeat an input signal during the quiet time.

7 - Quiet hours ident. If Timed operation was selected in menu 5, you can set if the repeater should send the ident signal during the quiet time.

8 - Half hour. Enables the transmitter to keyed in beacon mode during the first 30 minutes of every hour to save power

9 - Quad auto enable. Enables the quad display to be automatically displayed when more than 1 selected inputs are present.

10 - Enable DTMF input. Enables over air DTMF control of the repeater

11 - Apply changes

12 - Return to main menu

2 Callsign

Enables entry of the repeater callsign and QRA locator for display on generated captions.

3 Inputs

1 - 7 Input. Enables priority of each input to be set

8 - Input count. Set this to the total number of inputs on the video switcher - Do NOT include the controller in this number.

9 - Active Hold. Determines if a higher priority input will override the currently selected input.

10 - Apply

11 - Main Menu

4 Control

Enables direct selection of any input source

5 Update