Difference between revisions of "Repeater Controller configuration"
Jump to navigation
Jump to search
| Line 10: | Line 10: | ||
==Behaviour== | ==Behaviour== | ||
| + | |||
| + | 1 - Audio keepalive. Some HDMI switches shut down the audio channel is no audio is present. This option puts low-level white noise on the controller audio out to prevent this from happening. | ||
| + | |||
| + | 2 - Transmit enable. Enables transmit key line on pin xx | ||
| + | |||
| + | 3 - Beacon mode. Enables the controller to just run in beacon mode and ignore all inputs. | ||
| + | |||
| + | 4 - Power save. | ||
Revision as of 17:45, 13 February 2022
This page describes the set up of the BATC repeater controller - it should only be attempted by advanced users.
Enter the repeater controller menu log in to the RPi by SSH using a program such as Putty and type menu.
Reload
Loads the configuration changes you have made and restarts the controller
Behaviour
1 - Audio keepalive. Some HDMI switches shut down the audio channel is no audio is present. This option puts low-level white noise on the controller audio out to prevent this from happening.
2 - Transmit enable. Enables transmit key line on pin xx
3 - Beacon mode. Enables the controller to just run in beacon mode and ignore all inputs.
4 - Power save.